EMC Measurement System Based on Software Defined Radio and Diagnostic Techniques

리소스로 돌아가기

EMC_msrmnt_syst_basedon_SW_defined_radio&diagnostic_techniques.png

In a previous paper a new referenceless measurement set-up based on a reference antenna was used for characterizing the radiation of antennas in the planar scanner. The method is based on using a low-cost receiver to retrieve the amplitude and phase of the signal. This paper explores the limitations of the method for different geometries and implements a multiprobe electromagnetic compatibility measurement system. Once the amplitude and phase are recovered, diagnostic techniques can be applied and also near-field to near or far-field transformations to calculate the field at distances defined by standards. The results demonstrate the good accuracy of the method in comparison with traditional electromagnetic compatibility laboratories.

PDF 문서 다운로드

가상 상담원과 채팅하기